[help7]

i hope its the right discussion, but i did not find the correct forum...

i use hylafax (linux) on my server 4 sending fax messages. - now i try to use a nokia 6210 to connect.
the phone was found correct as class 1/2/2.0 modem.

but all i tried, if i send a fax, after a half page nothing or garbage comes out on the other side...
the error message in the logs is: no response to MPS or EOP

here's my (latest) attempt:
ModemType: Class1 # i've tried 1/2/2.0
ModemRate: 14400 # i've tried from 9600 up to 38400

################i've testet this / without success
#ModemFlowControl: xonxoff
#
ModemSetupDTRCmd: AT&D2
ModemSetupDCDCmd: AT&C1
#GettyArgs: "-h %l dx_%s"
#ModemDialCmd: ATDT%s

################i've testet this / without success
#ModemHardFlowCmd: AT&K3

#
Class1Cmd: AT+FCLASS=1
Class1PPMWaitCmd: AT+FTS=7
Class1TCFWaitCmd: AT+FTS=7
Class1EOPWaitCmd: AT+FTS=9
Class1MsgRecvHackCmd: ""
Class1TCFResponseDelay: 75
Class1SendMsgDelay: 75
Class1SwitchingCmd: AT+FRS=7
Class1TrainingRecovery: 1500
Class1RecvAbortOK: 200
Class1FrameOverhead: 4
Class1RecvIdentTimer: 40000
Class1TCFMaxNonZero: 10
Class1TCFMinRun: 1000

[auvinent]

Hello!

I have no clear answer, but I would start changing the baud rate and communication speed, have a go with SW flow control or dont use any.

Have a look also to "n6210Cable.inf" file (available at www.nokia.com) to see how the other FAX software will handle the fax related AT commands.

Have you subscribed a fax service to your SIM card?

Teemu / Forum Nokia