[Nokia_Archived]

Posted by Ariel Yaloz, arielyz@celltrex.com
on January 31, 2002 at 16:36

I have recently installed the Nokia Activ server and the Nokia Activ Alert packages. I'm trying to push a message to the Nokia simulator. I'm using the Nokia wap tool kit v3.0 and the active server v2.1. When trying to send a push message using the GUI push initiator, I get the following error: "The PGW has returned the following error: PGW is not accepting code=3000".
I've got the UDP traffic broker up and running, these are it's settings:
Nokia UDP bearer adapter
Bearer response size is not limited.
Not sending WCMP messages.
Push functionality is enabled.
Bearer address: 194.90.26.95
Valid prefixes:
*

Network types:
Type number: Network type: Bearer type: Address type:
------------------------------------------------------------------------------
0 Any Any IPv4

Bearer Properties:
LOCAL_IP_ADDRESS: 194.90.26.95:2948

WDP_D_TIME_MPL: 10

WDP_D_CAS_CACHE_USE: 0

WDP_D_CAS_CACHE_T: 100

WDP_D_CAS_FLUSH_LIMIT: 2

LOG_TRAFFIC: 1
Log all incoming and outgoing traffic
0:disable
1:enable
LOG_DEBUG: 1
Enable or disable debug info
0:disable
1:enable

I got the push subsystem up and running. But from some reason, I cannot start the Accepting/Sending/Request Hold On from it's configuration tab. I get the following error "Cannot start corresponding queue in PS_001. Check that push functionality is allowed. Error when changing queue state!".
I have also got the Push functionality enabled in the UDP bearer. I have set the bearer address to the address of my local host, and enabled all prefixes. Any ideas? Help!

[Nokia_Archived]

Posted by Nicodemus Chan, nicodemus@davidaslan.com
on March 04, 2002 at 21:46

Try creating a push connector.
"Push Subsystems"-->"my subsystem"-->Configuration tab-->Create button.

Then restart your activ server.

Try also allow push functionality:
"traffic broker"--"My Traffic Broker"-->UDP-->Push Tab-->check the "push functionality allowed" checkbox.